Introducing our “piggy-back” diesel heater remote controller. This device makes your “dumb” diesel heater “smart” by directly interfacing to the stock 4-button RF remote control using a WIFI enabled microcontroller. CbC Controller features a webserver allowing for timed events (e.g. heater off) and the setting of target temperatures to maintain (e.g. thermostat). It features an onboard temperature and humidity sensor with real-time clock module that will keep time even after power is lost.
To populate this board, you’ll need the following components:
1 x TTGO T-display (ESP32)
4 x 220 ohm 1/4W Resistor
1 x HTU21D (https://www.amazon.com/dp/B00XR7CR1I)
1 x DS3231 RTC (https://www.amazon.com/dp/B01N1LZSK3)
1 x 16-pin DIP socket (https://www.amazon.com/dp/B0079SM1LW)
1 x Sharp PC847
1 x 4-pin JST wire+connector
1 x 6-pin header
1 x Lipo battery (optional, not included)
Various wires (not included)
You may purchase the PCB only (pcb), partial kit (kit) or complete kit (kit-100) that includes the PCB and items above (note partial kit does NOT include the TTGO T-display/ESP32 while complete kit DOES). Soldering is required!
Software and more information can be found: CBC_ctrl Github.com
Cut by Caschy takes no responsibility for any damage or harm as a result of using this hardware and/or software. Cut by Caschy will not be liable for any loss, damage or injury directly or indirectly arising from the use of our products. Before using this product, the purchaser or user will determine the suitability of the product(s) for their intended use(s) and the purchaser or user shall assume all responsibility and risk in connection therewith.
